iPad Installation
Learn how to properly install your iPad into the Guac booth by following the guide below.
Table of Contents
Before You Start
QUICK START VIDEO
Steps
What to know
Before You Start
Required Parts
The following parts are required:
12.9” iPad Pro 3rd generation or newer
12.9” iPad Pro faceplate
Guac Head (with camera installed)
Philips head screwdriver
Quick Start Video
iPad Installation Walkthrough
In this video, you’ll learn how to:
Remove and replace the faceplate.
Install the iPad into Guac.
Securely connect the iPad to provide power and communication with the Canon camera, LED ring and printer.
Step One
Remove the Faceplate
Place the Guac head on a clean, flat surface with the camera facing up
Using a Philips head screwdriver, remove the six (6) screws found along the faceplate and put them aside in a safe place
Remove the faceplate from the Guac head and put it aside
Step Two
Install the iPad
Pick up and power on the iPad
Connect the USB-C power cable to the bottom of the iPad
Tip: If properly connected, you should see a blue connection icon appear in the top right corner of the screen.
Place the iPad onto the Guac head with the screen facing up
Carefully move the iPad to the bottom of the Guac head so that it aligns with the corners
Step Three
Replace the Faceplate
Take the faceplate and place it over the iPad
Tip: You may need to gently slide the iPad down toward the bottom of the Guac head so that the faceplate lays flat across all sides of the screen.
Replace all the screws in a cross-pattern to ensure equal pressure is applied on all sides.
Note: Do not over tighten the screws, as this may cause the faceplate to bend or add too much pressure to the screen.
What to Know
Install iPad Before Powering on Your Booth
Always have an iPad inserted before turning the booth on
Please note your warranty will be void if Guac is powered on without an iPad or the insert installed.
You can also use the cardboard insert instead of the iPad. Don’t throw this away!
